| FAQ_Q5 | Could calipers be the cause of a low brake pedal? |
| FAQ_Q4 | Brakes squeal all of the time. What's causing the squeal? |
| FAQ_Q7 | Do all of your Calipers come with the new hardware and a mounting bracket for installation? |
| FAQ_Q6 | What type of grease is used on floating caliper mounting pins? |
| FAQ_Q1 | Can I switch out a Phenolic Piston Caliper for a Steel Piston Caliper or vice versa? |
| Heavy Duty Supplier | Yes |
| Caliper Bracket Surface Finish | Coated |
| FAQ_Q3 | Car pulls to one side during braking. Why? |
| Caliper Type | Floating |
| FAQ_Q2 | What type of fluid should I use: DOT 3, DOT 4, or DOT 5? |
| Caliper Configuration | Semi-Loaded |
| Caliper Casting Material | Cast |
| Is Prop Sixty Five Affected | Yes |
| Caliper Piston Diameter | 50.979 |
| Mounting Bracket Included | Yes |
| Is the item CARB affected | No |
| Does it require SDS | No |
| Manufacturing Type | Remanufactured |
| Bleeder Screw Thread | M10x1 |
| Caliper Bracket Mounting Hole Size | 12 |
| Casting Number 1 | 2050, 2051, 2056 L AD51 21-13 |
| Is Or Contains A Battery | No |
| Dust Boots Included | Yes |
| FAA_A6 | A silicone grease is used on floating caliper mounting pins. |
| FAA_A7 | New hardware and Brackets are included with all of our Calipers when applicable. Mounting bracket inclusion is dependant on the application. Mounting Brackets are also sold separately for most applications. |
| FAA_A4 | Brake squeal can be caused by improper installation of the brake pads, improperly installed brake hardware and improper brake rotor finish. |
| FAA_A5 | A symptom of a low brake pedal is usually caused by air in the system, misadjusted rear brake shoes, deteriorated brake hose(s) or a defective master cylinder. |
| FAA_A2 | As a rule, always use brake fluid recommended by O.E. The fluid type is stamped on the master cylinder reservoir lid. Always use new fluid in a sealed container. |
| FAA_A3 | Inspect both calipers for binding or sticky slides or pins. Also ensure that brake hoses are not collapsed or restricted and inspect steering/suspension components for proper operation. |
| FAA_A1 | Not recommended. The O.E. manufacturers specified steel or phenolic pistons based on the intended use of the vehicle. It is recommended that the installer follow the manufacturer’s recommendations. |
| Is Or Contains A Bulb | No |
| Caliper Bracket Mounting Hole Thread Pitch | 1.25 |
| Bleeder Screw Cap Included | No |
| California Proposition 65 | WARNING: This product can expose you to chemicals including nickel, which is known to the state of California to cause cancer, and lead, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. |
| Surface Finish | Plain |
| Contains Electronic Components | No |
| E-Waste | No |
| Is Item A Chemical | No |
| Piston Quantity | 1 |
| Part Terminology | Disc Brake Caliper |
