| Is Prop Sixty Five Affected | No |
| Is the item CARB affected | No |
| End 1 Type | Bolt On |
| Pre Greased | Yes |
| End 2 Type | Bolt On |
| Is Or Contains A Battery | No |
| Product Condition | New |
| Tubing Outer Diameter (mm) | 64 |
| FAA_A6 | A universal joint is designed to allow prop shafts to move with suspension travel while the shaft is moving. This allows power to be transmitted when the prop shaft is angled between the transmission and differential. |
| CV Joints Included | No |
| Contains Electronic Components? | No |
| FAA_A4 | Not all vehicles will have a prop shaft. Prop shafts are most commonly found on all-wheel-drive and rear- wheel-drive vehicles. |
| FAA_A5 | Phasing is a used to describe the alignment of the yokes with each other at both ends of the prop shaft. The phase angle is the rotational position of each yoke on a prop shaft. |
| FAA_A2 | Each shaft is precisely balanced before boxing. Prop shaft balance is necessary for proper driveline operation. An unbalanced shaft can cause premature wear on other major components such as your transmission and rear differential. |
| FAA_A3 | This procedure entails the distribution of mass in the rotating prop shaft. The shaft is measured and altered where necessary to ensure that vibration does not occur during operation. |
| FAA_A1 | The most common causes of prop shaft vibrations are worn joints, an unbalanced drive shaft, poor joint lubrication, and a bent or twisted shaft. |
| Prop 65 | NO |
| Length (MM) | 927 |
| Universal Joints Included | Yes |
| E-Waste | No |
| Is Item A Chemical | No |
| Grease Fitting Included | Yes |
| FAQ_Q5 | What is prop shaft phasing? |
| FAQ_Q4 | Do all vehicles have prop shafts? |
| Features and Benefits | Units are 100% dynamically balanced at 3200 RPMs for vibration-free operation and increased joint life. |
| Is or contains a bulb? | No |
| FAQ_Q6 | What is a universal joint? |
| FAQ_Q1 | What causes prop shaft vibration? |
| Measurement Method | Measurement taken from end of flange face to end of flange face |
| FAQ_Q3 | How is a prop shaft balanced? |
| FAQ_Q2 | Are your shafts balanced? Why is it necessary? |
| Drive Shaft Material | Steel |
| Package Contents | Prop Shaft; Instruction Sheet |
| Drive Shaft Type | Universal Joint |
| Does it require SDS | No |
| First Application Year | 2003 |
| Length (in) | 36.50 |
| Greasable | Yes |
| Shaft Material | Steel |
| Is item a chemical? | No |
| SDS Required | No |
| Tubing Outer Diameter (in) | 2.50 |
| Compressed Length | 36.50 |
| Is the item CARB affected? | No |
| Shaft Diameter | 63.50 |
| Is Or Contains A Bulb | No |
| Is or contains a battery? | No |
| Slip Yoke | Yes |
| Contains Electronic Components | No |
| Grade Type | Regular |
| Part Terminology | Drive Shaft |
